Ulthera, Inc. Page 35
6. Treatment Guidelines
6.1. Preset Guidelines and Energy Levels
The Ulthera System is programmed with preset guidelines that have been
established through clinical experience. Table 6.1 describes the preset
guidelines available on your System.
Table 6.1 Guideline Names and Energy Lev els
Guideline Name
Energy Level
Range
Default
Energy Level
Face & Neck (Amplify) 1 – 4 2
Chest
DS 7-3.0 & DS 4-4.5 1 – 4 4
DS 10-1.5 1 – 4 3
General Regions (Face & Neck) 1 – 4 2
Train: Face & Neck (Amplify) 0 only 0
Train: Chest 0 only 0
To facilitate training with your system, specific training guidelines have been
pre-programmed into the guideline list as well. These are noted as “Train: …”
These training guidelines should be used for training purposes only where no
energy delivery is desired. Lines available for the transducer will not be
decremented while in a training guideline.
If regions other than those depicted in the preset guidelines are desired, it is
recommended that you utilize the User Regions function as described in
Section 7.2.3. This function will allow you to define text-based regions to select
and treat against.
Each transducer is programmed with set energy levels. Table 6.2 describes
the energy levels available for each transducer.
To Next Page
Loading...