ULTIMATE SPEED UMK 10 A1 User Manual

23
GB
tended;
- you are repairing or servicing the
appliance;
- the mains lead is damaged;
- foreign particles have got in or ab-
normal sounds are heard.
• Only use accessories supplied and rec-
ommended by the manufacturer.
• Do not try to repair the appliance your-
self.
Caution: How to avoid accidents
and injuries caused by electric
shock:
Electrical safety:
• Do not operate the appliance if its
On/Off switch cannot be set. Have
damaged switches replaced.
• Do not use the cable to carry the appli-
ance. Do not pull the cable to unplug
from the mains. Keep the cable away
from heat, oil and sharp edges.
• Attach the power cord to the vehicle’s
cigarette lighter only.
• Take heed of the cigarette lighter op-
erating instructions provided by the
manufacturer of your car.
• Immediately unplug the appliance from
the cigarette lighter if the cable is dam-
aged.
• The power cord of this appliance can-
not be replaced. If it damaged, the
appliance must be scrapped.
Initial Operation
Set up the device on a level,
non-combustible surface. The
vent holes must not be cov-
ered. Do not operate the de-
vice in a dusty environment.
There is a risk of re and the
device could be damaged.
For an inatable item with counter-
pressure (e.g. partially lled tyres):
switch on the device before con-
necting the connection valve to the
tyre.
Depending on the inatable item,
the connection valve (7) can be
used directly or in conjunction with
the valve adapters (10) included in
the delivery contents.
Connecting the device to the ciga-
rette lighter:
Ensure that the cigarette lighter
socket of your vehicle is adequately
fused.
1. Ensure that the device is switched off:
on/off switch ( 6) in “0” position.
Plug the cigarette lighter plug ( 5)
into the 12 V cigarette lighter socket.
Connecting the connection valve (7):
2. Open the connection valve (7):
tensioning lever (8) vertical up-
wards (position

).
3. Connection without valve adapt-
er (10):
- Plug the open connection
valve (7) into the valve on the
inatable item (remove the
valve cap on the inatable
item beforehand if neces-
sary).
- Hold down the connection
valve and close it: push the
tensioning lever (8) towards
the connection valve (position

).
4. Connection with valve adapter
(10):
- Push the respective valve

ULTIMATE SPEED UMK 10 A1 Specifications

General

Brand	ULTIMATE SPEED
Model	UMK 10 A1
Category	Air Compressor
Language	English