ULTIMATE SPEED UPK 10 E2 - Troubleshooting

20 GB/IE/NI/CY/MT
 Attention: As soon as the
vehicle starts, remove the jump
lead
18
from the power bank
with compressor
1
within
30seconds and firstly disconnect
the black battery clamp (B) and
then the red clamp (A) from the
battery poles. Otherwise, it could
result in dangerous situations!
 Leave the vehicle engine
running.
z FAQ
Q: Question
A: Answer
Q: How long does it take to
fully charge a mobile phone
with the device?
A: With a battery capacity of
3500mAh: Approx. 3–4 hours
if connected to the USB output
5V
/1A
12
. Approx. 2–3 hours
if connected to the USB output
5V
/2A
11
. Please note that
if the device is switched on, it will
continually use battery power while
actually charging and this can
extend the charging time.
Q: How long does the power
bank with compressor
1
hold
a full charge?
A: 3–6 months. However,
we recommend recharging the
battery monthly.
Q: How is the power bank
with compressor
1
switched
off?
A: After switching on the power
bank with compressor
1
with
the power bank switch
9
, the
power bank with compressor
switches off automatically after
approximately 20 seconds if the
compressor is not started or if no
consumables are connected.
A manual switching off of the
device is not provided for.
z Troubleshooting
= problem
= cause
= remedy
The power bank with
compressor
1
is not fully
charged, even though all
4indicator lights
13
are
permanently lit.
It is 60% charged after a long
period out of use or in storage.
Recharge the power bank with
compressor
1
as described in
thesection “Charge power bank
with compressor”.
Power bank does not
respond when power bank
switch
9
is pressed.
Deep discharge protection
active on the power bank with
compressor
1
.