Add more coating if needed by pouring it
directly into the coating bowl.
Start Up Procedure
Inspect the coating filter to ensure that
there are no air bubbles. If so, release
any air bubbles from the filter using the
bleeder cap. Refer to pages 19 & 22
** When bleeding air from the filter, make sure to only open the
cap a 1/4 of a turn and continue to hold on to the cap. This will
prevent the bleeder cap from blowing off from the pressure of the
coating pump.**
Prime the coating for 5 minutes.
Check the coating reservoir to make
sure the coating level is high enough.
The coating level should be at least ½
full.
2
To Next Page
Loading...