www.ultratecfx.com
15
10” Automatic Round Damper
The 10” Automatic Round Damper (ARD) is an inline damper that will open or close to allow or prevent fog from
owing down a run of 10” ducting. When using with a ‘Y’ connector as illustrated, fog may be diverted down
either or both branches of ducting. The unit operated using 110 VAC and may be eld set to open or close upon
receiving power. Two leads are provided for power connection. The ARD is constructed of galvanized steel and ts
inside 10” rigid pipe and held with sheet metal screws or inside a 10” ex pipe and held with a worm gear clamp.
DMX control can be obtained by using a DMX relay control like the CLF 2944 LSG DMX Interface 110 Volt. The
ARD may also be used as a cost effective back ow prevention device.
Flex to Rigit Adapter
The CLF 9033 10” Adaptor (Flex Hose to Rigid) is used when a connection between ex hose and rigid pipe is
needed.
Rigid Pipe Hose Adapter
CLF 2957 LSG MKII Rigid Pipe Hose Adaptor is used with the LSG Touring Road Case model and extends the LSG
fog output to outside the road case where pipe connections can be made easier.
To Next Page
Loading...