water could damage it and have an effect on its functioning
ELECTRIC CABLE: Make sure that the cable and plug are in perfect conditions. Electric
cables must be away from hot surfaces
SCREWS AND CONNECTING CABLES: Supervise and tighten the screws on a regular basis,
because due to the vibration the screws and nuts tend to loosen.
LUBRICATION: It’s a correct lubrication of the treadmill with silicon oil or
teflon is really important. This lubrication must be performed regularly
depending on its use even before the first use.There is a hole for adding
oil on motor cover. After starting machine, please change to highest
speed, then add the oil into the hole, the oil will be spread from the
middle between the running belt and board.
ALIGN AND TIGHTEN THE BELT OF THE TREADMILL
ALIGN THE BELT: Due to its use, the belt can move off center. If the belt has moved to the
left, start treadmill and increase the speed to 3MPH .Use the 5mm Wrench to turn the fixed
left bolt clockwise or turn the fixed right bolt counterclockwise. Don’t tighten the belt too
much in order to be able to walk. Repeat this procedure until the belt is properly aligned.
如果跑带左偏,则顺时针调节左
边螺丝或逆时针调节右边螺丝
如果跑带右偏,则顺时针调节右
边螺丝或逆时针调节左边螺丝
If deviate to the
right, then adjust the
screw on the right side
clockwise or the screw
on the left side
anticlockwise.
If deviate to the left,
then adjust the screw on
the left side clockwise or
the screw on the right
side anticlockwise.
To Next Page
Loading...
