TIGHTEN THE BELT: (if the belt slips on the treadmill when walking). Start treadmill and
increase the speed to 3MPH.Using the
5mm wrench
, turn both bolts 1/4 clockwise. If the belt
is properly tight to walk, you must be able to pull up each side of the belt 5 or 7 cm off the
platform. Be careful and maintain the belt aligned. Repeat this procedure until the belt is
properly tightened.
TIGHTEN THE DRIVE BELT:if the drive belt becomes loose after using for a period of
time,you need to:
(1) Open the motor cover .
(2) Use the 5mm wrench to turn the adjusting
bolt clockwise.
Repeat this procedure until the drive belt is not slippery anymore.
CLEANING: Don't use abrasive products. A damp cloth is enough.
LEVELING: If your unit is provided with leveling wheels, please adjust them in order to
avoid vibrations and therefore malfunctions.
KEEP THESE MAINTENANCE ADVISES FOR FUTURE REFERENCES
if the running belt slips,use 6mm
wrench,turn both sides bolts 1/4
clockwise.Repeat this procedure until
the belt is properly tightened.
To Next Page
Loading...
