UNAOHM EP2500 - MPEG Program Monitoring; Audio Channel Selection; Messages

UNAOHM
EP2500 (Rev. 0)
47
10.2.1 MPEG Program Monitoring
By means of the Shaft Encoder mark the desired program, then press the multifunction key F4 or ↵
ENTER
(21).
Follow the same procedure to select a radio program.
The MPEG card takes a few seconds to select the program chosen from the Data Stream and to
decompress it before displaying it on the screen.
To return to the Network Information Table then press the multifunction key F4 or ↵ ENTER (21).
To return to BER display press the multifunction key F1.
At the bottom of the display appears the name of the tuned program and the video and audio PIDs
in decimal format.
It is possible to select the various free-to-air video programs in sequence by means of the Shaft
Encoder or the multifunction keys F2 (UP) and F3 (DOWN). .
10.2.2 Audio Channel Selection
If the program being viewed contains more than one audio channel, it is possible to select them in
sequence by pressing the key SOUND (22).
10.2.3 Messages
Some informative messages about the status of the reception may appear on the screen for short
periods of time.