4
3.0 Installation
3.1 Installing the Bottle
• Open the compartment on the handheld unit by sliding the green button back and
removing the lid (picture 1).
• Remove bottle from unit and unscrew cap (picture 2). Fill with desired cleaning solution
and replace the cap (picture 3).
• Do not fill bottle inside handheld unit.
• Maximum of 5 oz of liquid. Do not squeeze or overfill the bottle.
• Cap should have a tight seal prior to placing inside unit.
• Do not use liquids other than conventional window and glass cleaners.
DO NOT USE with concentrates, creams, gels, abrasive formulas or chemicals
containing bleach.
2.0 System Overview
Stingray
®
is a modular system. The handheld cleaning unit consists of the triangular cleaning head equipped with
either a microfiber pad or adapter plate and QuikPad
™
, depending on the kit purchased. The head is flexible and has an
embedded spray jet in the center. The body of the unit can be opened to change the bottle and to change batteries.
The handheld unit can be used as a hand tool or can be extended/collapsed with extension poles. The activation button
on the back of the unit is used to release the cleaning solution.
Every pole section has an activation button to release the cleaning solution.
Stingray
®
Extension Pole -
Short
1.5’/.5m
Stingray
®
Extension
Pole - Long
3.5’/1.1m
Stingray
®
Handheld
Stingray
®
Refillable
Bottle
QuikPad
™
and
Adapter
Refer to Installation images on pages 4-6
2
1
Button
Lid
Pin Hole
Connector
To Next Page
Loading...