2. Set the rotary switch to
o
C
or
o
F
.
3. Place the temperature probe to the object being measured.
The measured value shows on the display.
Note
l The Meter automatically displays the temperature value inside the Meter when
there is no temperature probe connection.
l The included point contact temperature probe can only be used up to 250
o
C(482
o
F).
For any measurement higher than that, the rod type temperature probe must
be used instead.
l When temperature measurement has been completed, disconnect the connection
between the testing leads and the circuit under test.
Measurement Operation (14)
26
Model UT33B/C/D: OPERATING MANUAL
To Next Page
Loading...
