Unic URW295CUR - Mode Switching Procedures; Switching Between Manual and Radio Control Modes

TRAVEL LEVER STAND
LOCK LEVER
STAND LEVER
TRAVEL LEVER
CRANE OPERATION POSITION TRAVEL POSITION STOWAGE POSITION
7.1 Switching of mode ( Manual mode ⇔ Radio control mode )
However, this operation is possible under the following condition.
１） Starter switch on.
２） Shift the travel lever to “CRANE OPERATION” position.
３）
Push the mode selector switch to switch it to the radio remote control mode.
The
Mode indicator lamp
Manual mode Radio control mode
The Mode indicator lamp lights off. The Mode indicator lamp lights on.
Manual lever only Radio control only
（７－１）
Courtesy of Machine.Market