Unical KON - Adaptation of the Power to the Heating System

27
Installation Instructions
ENGLISH
ATTENTION!
Function reserved for Authorised
Assistance Centres only.
It is possible to adjust the maximum thermal capacity
in heating mode, by decreasing the burner output
value.

E.g.
to decrease the output of the
boiler to 24 kW, edit parameter
HP (about 85)
.
Act on parameter  (par. 4.2 parameters that can
be edited from control panel) to achieve the value
corresponding to the desired output.
The user is NOT authorised to activate the func-
tion described below.