Unical KON - Parameters that Can be Edited from the Control Panel

30
OK
5
6
ATTENTION!
Function reserved for Unical AG S.p.A.
Authorised Assistance Centres only.
Some service parameters can be edited
from the control panel:
 
1 ACTIVATION
By pressing the button (D) for 10 seconds, the
function is activated when the key ashes on the
display
EXTERNAL PROBE TEMPERATURE
VALUES
FROM A DEFAULT
0 (- 20°C) 30 (+ 10°C) (0°C)
PUMP POST CIRCULATION
VALUES
FROM A DEFAULT
0 (5 min) 1 (ALWAYS) 0 (5 min)
SELECTION
Turn the HEATING knob ‘’B’’

OK

VALUES
FROM TO TO
DEFAULT
0 (TA -0°) 5 (TA -5°) 30 (TA -30°) 0 (TA -0°)

VALUES
FROM TO DEFAULT
0 (Min) 99 (Max) 99

VALUES
FROM TO DEFAULT
0 1 0

Turn the DOMESTIC HOT WATER knob ‘’C’’
The value ashes on the display
CONFIRM SELECTION
Conrm the parameter to be edited by pressing
the unblock key
CONFIRM VALUE
Conrm the value by pressing the unblock key
PARAMETER SELECTION
Go back to section .
4
3
5
6