Unical KONf 115 - Operation Parameters

31
Maintenance instructions
ENGLISH
SE SERVICE PARAMETER
Press the buttons indicated simultaneously to enter in the
service mode SE and change value.
A Operation READING PARAMETER
Press the button indicated to view default setting
C Operation SET / MODIFY PARAMETER
Push the button shown
4.4 - PROGRAMMING OF THE OPERATION PARAMETERS
ATTENTION!
Function reserved for Authorised Assistance
Centres only.
B Operation CHANGE PARAMETER
Press key + (PLUS) / - (MINUS) to modify
BURNER MODULATION LEVEL IN IGNITION - ( 1 )
Continue with the modication of parameters by pressing
the (MINUS)
Repeat the operations A-B-C to change value
VALUE
FROM TO DEFAULT
KONf 100 KONf 115
0 99 Methane 28 28
0 99 Propane 28 28
The user is NOT authorised to activate the function de-
scribed below.