Unical KONf 115 - Power Adaptation to Heating System

27
ENGLISH
Installation Instructions
FH (%)
Es:
to decrease the output of the boiler to 70 kW, edit parameter
HP (about 79).
ATTENTION!
Function reserved for Authorised Assistance
Centres only.
The user is NOT authorised to activate the
function described below.
It is possible to adjust the maximum thermal capacity in heating
mode, by decreasing the burner pressure value.
3.12.1 - ADAPTATION OF THE POWER TO THE HEATING SYSTEM
Power Supply (KW)
Act on parameter FH (par. 4.2 SE parameters list) to achieve
the value corresponding to the desired output.