10.
Installation of lip seal - continued
Disassembly of the body
III. Assembly of the snap ring
Tools required: • Snap ring pliers (hole) • Seal installer
Procedure: Insert the snap ring into nose section (tapered
part of the snap ring must be facing downwards).
Push the snap ring downward with the installer, and t into
the groove.
IV. Assembly of the felt seal
Tools required: • Installer seal
Procedure: Install the felt seal into the nose section.
Push the felt seal until it touches the snap ring.
Caution - O-ring should not be reused.
I. Removal of oil
Procedure: Remove the drain plug and drain the oil.
II. Removal of lipseal (Refer to page 9 for instructions)
III. Removal of the bolts on rear cap
Tools required: • Socket wrench • Socket 6mm hex • Stand
Procedure: Remove the M8 securing bolts (4pcs) from the
rear cap.
IV. Removal of the rear cap
Procedure: Remove the rear cap by gently inserting a screw
driver or lever into the recess. Lever all around, not just at one
position.
Caution - Do not damage the cap or body.
Guide sleeve
Guide sleeve
Lipseal
Seal
installer
To Next Page
Loading...