Bulletin 30-121.2014.04.014
(SAC 37.4255.109.00)
Copyright © 2014 Unico, Inc.
Installation site selection - Indoor unit
AVOID
•
Direct sunlight.
•
Nearby heat sources that may affect unit
performance.
•
Areas where leakage of flammable gas may be
expected.
•
Locations where large amounts of oil mist may occur
(such as in kitchen or near factory equipment) because
oil contamination can cause operation problems and
may deform plastic surfaces and parts of the unit.
•
Unsteady locations that will cause noise or possible
water leakage.
•
Locations where the remote control unit will be
splashed with water or affected by dampness or
humidity.
•
To make holes in areas where electrical wiring or
conduits are located.
DO
•
Select an appropriate position from which every corner
of the room can be uniformly cooled.
•
Select a sufficiently strong location to support the
weight of the unit.
•
Select a location where tubing and drain hose have
the shortest run to the outside.
•
Allow access for operation and maintenance as well
as unrestricted air flow around the unit.
Installation site selection - Outdoor unit
AVOID
•
Heat sources, exhaust fans.
•
Direct sunlight.
•
Damp, humid or uneven locations.
•
To make holes in areas where electrical wiring or
conduits are located.
DO
•
Choose places as cool as possible and well
ventilated.
•
use lug bolts or equal to bolt down the unit,
reducing vibration and noise.
To Next Page
Loading...
Need help?
General
