Unico PowerSpin C8604 User Manual

4
Caution: Make sure the voltage of the power source matches the voltage input of
centrifuge.
Control Panel and Key Pad Controls
The PowerSpin C8604 centrifuge control panel appears as per the diagram below:
ddd
Timer, Time Setting and Time Setting Change
Timer setting: Use the up or down arrow to preset the running time. The timer range is
1 to 60 minutes in 1 min. increments. While running, the display will show the
timer count down in real time.
Time setting review change during operation:
1) To check time setting during operation, press either up or down arrow.
2) To change timer setting during operation, press and hold the up or down arrow
button for more than 2 seconds. To increase time setting, press and hold up
arrow, otherwise, down arrow button.
Speed Setting and Speed Setting Change:
Speed Setting: Use the up or down arrow to preset the running speed. The speed range is
From 1,000 to 3,400 RPM in 100 RPM increments. The display will show
Actual running speed and RCF (g) force in real time.
Speed Setting Check and Change During Operation:
3) To check speed setting during operation, press either up or down arrow.
4) To change speed setting during operation, press and hold the up or down arrow
button for more than 2 seconds. To increase speed setting, press and hold up
arrow, otherwise, down arrow button.
Start Button: Press Start button to spin sample. The centrifuge will not spin if the lid is
not closed or not properly closed.
Speed Timer
START
STOP
OPEN
▼ ▲
RCF: xxxxx Status: Running
Spd: xxxx Time: xxxxx
▲ ▼

Unico PowerSpin C8604 Specifications

General

Brand	Unico
Model	PowerSpin C8604
Category	Laboratory Equipment
Language	English