02
www.unicorn-darts.com
Take a drill and make two
appropriate holes where you
have made your two 15mm
marks using a 5.5mm drill bit.
Find a point on the wall
where you would like your
Unicorn® Smartboard® to
hang. Measure 1730mm
from the oor to where the
centre of your Unicorn®
Smartboard® will hang. Make
a small mark with a pencil.
Once you have drilled your
holes, push in your wall plugs
then take the two screws
supplied in the hanging pack,
and guide them through the
holes in the bracket. Then
screw the bracket into the
drilled holes.
From your pencil mark,
measure left and right 15mm.
Ensure your measurements
are straight, use a spirit level
if you have one. Then make
one mark 15mm to the
left of your rst mark, and
another 15mm to the right
of your rst mark.
Remove the battery cover
on the reverse of the
Unicorn® Smartboard®. Then
insert the three AA batteries
supplied. ENSURE CORRECT
POLARITY ALIGNMENT
STEP 01
Assembly
instructions
for your new
Unicorn®
Smartboard®
STEP 02
STEP 03 STEP 04 STEP 05
To Next Page
Loading...
