03
www.unicorn-darts.com
Take the nal screw, and
screw it into the back of the
board. Leave approximately
5mm of the screw
protruding from the board.
You can now hang your
Unicorn® Smartboard®.
Download the Unicorn®
ScoreBuddy® app,
alternatively scan the
QR code.
Lift your Unicorn® Smartboard®
and mount to the wall
bracket on your wall. The
screw in the board should
slide down into the centre
of the bracket. Check this
is stable and adjust the
Unicorn® Smartboard® screw
if necessary.
Open the Unicorn®
ScoreBuddy® app.
Use the Oche mate to mark
the throw line. This should
be 2.37m from the face of
the dartboard. Alternatively
measure 2.93m diagonally
from the bullseye to the oor.
Allow Permissions and
ensure your device’s
Bluetooth® is switched
on. Follow your devices
manufacturer’s instructions.
iOS Code Android Code
STEP 09 STEP 10 STEP 11
STEP 07STEP 06 STEP 08
To Next Page
Loading...
