What to do if my Uniden Scanner won’t start scanning?
If the Uniden Scanner won't start scanning, ensure you are in service or favorites mode by pressing (Srvc/Fav). If HOLD is displayed, press (Hold) to resume. Also, the squelch may need adjustment, so adjust the squelch threshold. Check the antenna connection as well.
Why does my Uniden EZI33XLT+ Scanner scan won’t stop?
If the Uniden Scanner scan won’t stop, you may need to adjust the squelch threshold. Also, check the antenna connection. Ensure the channel’s frequency is stored in the scanner’s favorites bank. Finally, the channel might not be active, so wait for a transmission on the channel.
How to improve the reception on my Uniden EZI33XLT+?
If you are experiencing improper reception on your Uniden Scanner, check the antenna connection, or move or reposition the antenna. You can also try moving the scanner to a different location. If you are in a remote area, you might need an optional multi-band antenna. Check with your dealer or local electronics store.
What does ErrChg flashing mean on my Uniden EZI33XLT+?
If the 'ErrChg' message flashes on your Uniden Scanner, it indicates that the battery cannot be charged because you are using an alkaline battery or a defective nickel metal hydride battery.
Safety and usage guidelines before operating the scanner, including battery and earphone warnings.
Step-by-step guide on how to install and replace AA NiMH batteries in the scanner.
How to attach the supplied flexible antenna to the scanner's BNC connector.
How to plug in a 3.5mm earphone for private listening and a related safety warning.
Details the functions of the scanner's keys and their labels for operation.
Explains the meaning of various icons and information shown on the scanner's display.
Step-by-step instructions for turning the scanner's power on and off.
How to adjust the squelch level to filter out noise and improve reception.
Instructions on how to control the audio volume level of the scanner.
Details on using and storing frequencies in the 3 Instant Channels for quick access.
Detailed steps for storing frequencies into Favourites banks and Instant Channels, including editing.
Solutions for poor signal reception, including antenna and location adjustments.
Troubleshooting steps for when the scanner does not stop on a transmission.
Steps to resolve issues when the scanner fails to initiate scanning.
Procedure to reset the scanner to factory defaults, clearing all stored data.
General| Channels | 180 |
|---|---|
| Priority Scan | Yes |
| Display | LCD |
| Service Scan | Yes |
| Frequency Steps | 5, 12.5 kHz |
| Power Source | 2 x AA batteries |
| Frequency Range | 25-88MHz, 108-174MHz, 406-512MHz |
To Next Page
