Hardware Overview
LED
Reset
LED The LED will flash blue during bootup. When the camera
is ready to connect to the Wi-Fi network, the LED pattern
will flash two times accompanied by two beep tones. Once
connected to the network, the LED will glow with a steady
breathing pattern.
State Status
Alternating
White/Blue
Device is busy; do not touch or unplug it.
This usually indicates that a process such
as a firmware upgrade is taking place.
Steady Blue Connected to controller.
Flashing White Connecting to Wi-Fi
Steady White Wi-Fi Connected, Awaiting Configuration
Reset To reset network settings to factory defaults, press and
hold the Reset button until the camera emits two short tones.
To Next Page
Loading...
