Uniflame GBC1747WPF-U

Questions and Answers

T
Timothy BerryAug 16, 2025
How to fix Uniflame GBC1747WPF-U igniter not working?
- C
  Christopher HamiltonAug 16, 2025
  If the burner on your Uniflame Grill won't light using the igniter, several factors could be the cause. First, ensure the gas cylinder valve is open and the regulator is securely attached. If the gas cylinder is low or empty, refill or replace it. If you suspect LP gas issues, turn the gas cylinder valve to 'CLOSED,' wait 5 minutes, and then check for leaks. Also, inspect the wires and electrode for cooking residue and clean them with rubbing alcohol if needed. Wipe the electrode and burners dry if they are wet. If the electrode is cracked or the wire is loose, disconnected, or shorting, replacement parts may be needed. A bad igniter can also prevent ignition, in which case replacement parts are also needed.
Z
Zachary NguyenAug 19, 2025
What to do if my Uniflame GBC1747WPF-U Grill has a flare-up?
- A
  April BrownAug 19, 2025
  If your Uniflame Grill experiences a flare-up, it's likely due to grease buildup or excess fat in the meat. Remove and clean all grill parts. Trim fat from meat before grilling to prevent future flare-ups. Also, excessive cooking temperature can cause flare-ups, so adjust to a lower cooking temperature.
T
Teresa TuckerAug 22, 2025
Why won't my Uniflame GBC1747WPF-U Grill burner light with a match?
- J
  Jerry RileyAug 22, 2025
  If your Uniflame Grill burner won't light with a match, there could be several reasons. Check if the gas cylinder is empty and exchange, refill, or replace it if needed. If the gas cylinder is not empty, there may be an obstruction of gas flow. Clear the burner/venturi tube and check for a bent or kinked hose. Also, make sure the coupling nut and regulator are fully connected, tightening by hand only. Ensure the burner is properly engaged with the valve. Spider webs or insect nests in the venturi or clogged burner ports can also prevent lighting; clean these as necessary. If you suspect LP gas issues, turn the gas cylinder valve to “OFF”, wait 5 minutes, and then check for leaks.
J
Jennifer YoungAug 26, 2025
What causes a sudden drop in gas flow in my Uniflame GBC1747WPF-U Grill?
- J
  Julia WeissAug 26, 2025
  A sudden drop in gas flow or reduced flame height in your Uniflame Grill can be due to a couple of reasons. The most common is simply running out of gas, so exchange, refill, or replace the gas cylinder. Alternatively, the overfilling prevention device may have been activated. To reset it: 1. Turn control knobs to • (OFF). 2. Wait 30 seconds and light grill. 3. If flames are still too low, reset the overfilling prevention device: a. Turn control knob(s) • (OFF). b. Turn Gas cylinder valve to “CLOSED”. c. Disconnect regulator. d. Turn control knobs to (HIGH). e. Wait 1 minute. f. Turn control knobs to • (OFF). g. Reconnect regulator and leak check connections, being careful not to fully open valve. h. Light grill.
J
Jesse AdamsAug 28, 2025
Why is the flame yellow on my Uniflame Grill?
- G
  Garrett RandolphAug 28, 2025
  A yellow or orange flame on your Uniflame Grill can be caused by a few things. If it's a new burner, it may have residual manufacturing oils; burn the grill for 15 minutes on high with the lid closed to resolve this. Spider webs or insect nests in the venturi can also cause this issue; clean the venturi. Food residue or grease on the burners is another possibility, so clean the burner. Finally, poor alignment of the valve to the burner/venturi tube can be the culprit; ensure the burner/venturi tube is properly engaged with the valve.
D
Dr. Melissa SmithAug 31, 2025
Why does my Uniflame GBC1747WPF-U Grill flame keep going out?
- J
  Jill MillerAug 31, 2025
  The flame on your Uniflame Grill might be going out due to several reasons. High or gusting winds can extinguish the flame, so avoid using the grill in such conditions. Also, check if you're low on LP gas and exchange, refill, or replace the gas cylinder if needed. The overfilling prevention device may have been activated.
V
victoriaalvaradoSep 3, 2025
How do I fix an irregular flame pattern on my Uniflame Grill?
- H
  Hayley LeonardSep 3, 2025
  An irregular flame pattern on your Uniflame Grill, where the flame doesn't run the full length of the burner, is typically due to clogged or blocked burner ports. Clean the burner ports to resolve this issue.
L
Lisa RobertsonSep 6, 2025
What causes flashback in my Uniflame GBC1747WPF-U?
- E
  Eric ButlerSep 6, 2025
  Flashback, or fire in the burner tubes of your Uniflame Grill, is caused by blocked burners and/or burner/venturi tubes. Clean the burners and/or burner/venturi tubes to resolve this.
C
Courtney AustinSep 9, 2025
What to do about a persistent grease fire in my Uniflame Grill?
- S
  Stephen LeonardSep 9, 2025
  If you have a persistent grease fire in your Uniflame Grill, it's likely due to grease trapped by food buildup around the burner system. Here’s what to do: 1. Turn control knobs to • (OFF). 2. Turn gas cylinder valve to “OFF”. 3. Leave lid in closed position and let fire burn out. 4. After grill cools, remove and clean all parts.
M
Melissa LewisSep 12, 2025
Why is the inside of my Uniflame Grill lid peeling?
- S
  Susan CookSep 12, 2025
  If the inside of your Uniflame Grill lid is peeling, it's likely due to baked-on grease buildup that has turned to carbon and is flaking off. Clean all grill parts.

Summary

Important Safeguards

Regulator and hose

Information on the gas regulator and hose, including compatibility, life expectancy, and replacement.

Gas Cylinder

Guidelines for handling, storing, and using gas cylinders safely, including safety warnings.

Expanded View

Parts List

A detailed list of all components included with the grill, identified by number.

Hardware

A list of hardware items used for assembly, with specifications and quantities.

Tools Required for Assembly

Identifies the tools needed for assembling the gas BBQ grill.

Installing LP Gas Cylinder

Gas Regulator

Details the parts of the gas regulator and provides instructions for connection, operation, and disconnection.

Operating Instructions

Checking for Leaks

Procedure for performing a leak test on gas connections to ensure safety before operation.

Operating Main Burners

Step-by-step guide for lighting and operating the main burners of the grill.

Lighting

Instructions on how to safely light the grill's burners, including backup methods.

Cleaning and Care

Cleaning Surfaces

Methods for cleaning the exterior surfaces of the grill.

Cleaning Main Burners

Detailed steps for cleaning the main burners, including removing and inspecting them.

This document is the owner's manual for the UniFlame Gas BBQ Grill, models GBC1747WPF-U, GBC1747WRS-U, and GBC1747WBS-U (ASDA Spec Codes: 16B.02.17.031, 168.02.17.032, 168.02.17.033). It provides comprehensive instructions for assembly, operation, maintenance, and troubleshooting to ensure safe and effective use of the barbecue grill.

Function Description

The UniFlame Gas BBQ Grill is designed for outdoor cooking using liquid propane (LP) gas. It features multiple main burners and a side burner, allowing for versatile cooking options. The grill includes a lid with a temperature gauge, warming rack, cooking grids, and heat plates for even heat distribution. A grease cup and tray are integrated for easy cleaning. The grill is equipped with control knobs for adjusting flame height and an integrated ignition system for convenient startup. It is designed for residential use only and is not intended for commercial applications or as a heater. The grill is supplied with a 27 mm clip-on propane regulator suitable for use with propane patio gas cylinders.

Important Technical Specifications

Appliance Category: 13+
Weight: 33.5 kg / 73.8 lbs
Dimensions (L x W x H): 138cm x 62cm x 118cm
Grilling Surface (L x W): 73.0cm x 42.0cm
Load Weight:
- Side shelf: Max. 15 kg.
- Side burner table: Max. 15 kg.
Heat Quantity:
- Main burner: 14.08 kW (48,000 BTU)
- Side burner: 3.52 kW (12,000 BTU)
- Total: 17.6 kW (1256 g/h)
Gas Type: Butane / Propane
Pressure Regulator: Preset and CE-approved pressure regulator
Flow Rate: Max. 1.5 kg/h
Operating Pressure: 28-30 mbar Butane / 37 mbar Propane
Gas Cylinder: Standard gas cylinder with a fill weight of 11 or 15 kg (precision-filled, between 11kg and 15kg).
Gas Hose: CE approved hose (Max 1.5 m)
Ignition Type: Integrated ignition
Flame Regulation: Infinitely adjustable 1 - max.
Nozzle Diameter: 0.92mm main / 0.92mm side
Minimum Clearances: 91.4 cm from sides and back to combustible construction. 1 m from the side or rear of the appliance to overhead obstructions.
Regulator Life Expectancy: Estimated as 10 years.

Usage Features

Outdoor Use Only: The grill must be used outdoors in a well-ventilated area, away from combustible materials, buildings, garages, or any enclosed spaces.
Gas Cylinder Connection: The grill requires a precision-filled gas cylinder (11-15kg) and is supplied with a 27mm clip-on propane regulator. Instructions detail how to properly connect and disconnect the gas cylinder, ensuring the regulator valve handle is in the "OFF" position before connecting/disconnecting.
Leak Testing: A critical safety step before each use and after connecting the gas cylinder. Users are instructed to create a soap solution and apply it to all gas connections; bubbles indicate a leak.
Ignition System: Features an integrated ignition for main and side burners. Users are instructed to open the lid, turn the control knob to "HIGH," and push to light. If the igniter fails, a lighting rod (included) can be used with a lit match.
Flame Control: Control knobs allow for infinitely adjustable flame regulation from minimum to maximum.
Flare-up Minimization: Recommendations include trimming excess fat from meats, cooking high-fat content meats on a low setting or indirectly, and ensuring the grill is on a level, non-combustible surface.
Excess Flow Check Device: The regulator may include a safety device that limits gas escape in case of a leak. Instructions explain how to reset this device if activated.
Side Burner: Can be used concurrently with main burners for additional cooking. Maximum weight for the side burner and side shelf is 15 kg.
Safety Warnings: The manual emphasizes numerous safety precautions, including not moving the appliance during use, turning off the gas supply after use, not modifying the appliance, keeping children and pets away, not using charcoal or lighter fluid, and never operating unattended.

Maintenance Features

Regular Cleaning: The grill should be thoroughly cleaned and inspected on a regular basis. All cleaning and maintenance should be performed when the grill is cool and the fuel supply is disconnected.
Burner Cleaning: Detailed instructions are provided for cleaning main and side burners, including removing fasteners, lifting burners, cleaning venturi tubes with a small bottle brush or compressed air, and clearing clogged ports with a stiff wire.
Surface Cleaning: Surfaces can be cleaned with mild dishwashing detergent or baking soda mixed with water. For stubborn stains, a citrus-based degreaser and a nylon scrubbing brush are recommended. Abrasive cleaners and oven cleaner should not be used.
Hose Inspection: The hose should be inspected before each use for abrasion, wear, cuts, or leaks and replaced if damaged.
Storage: Before storing, the gas cylinder must be disconnected and stored outdoors in an upright position, away from flames and direct sunlight. The grill itself can be stored indoors if the cylinder is removed, or outdoors with a grill cover for protection.
Burner Flame Conditions Chart: A visual guide helps users identify if their burners need cleaning or replacement based on flame appearance (normal soft blue with yellow tips, noisy hard blue, or wavy yellow).
Troubleshooting Guide: A comprehensive section addresses common issues such as burners not lighting, sudden drops in gas flow, irregular flame patterns, yellow/orange flames, flame going out, flare-ups, persistent grease fires, and flashback, providing possible causes and prevention/cure steps.