Uniforest 35M User Manual

15
REMOVAL OF FAULTS
Determined faults
Cause
Procedure for removal of
(malfunctions)
faults (trouble)
Insufficient
Grease on frictional padding
Replace clutches.
pulling force.
of the clutch.
Burnt frictional padding of the
Clean padding with
clutch.
sandpaper or grind
(thickness approximately 0.5
mm).
Improper setting.
Setting according to
instructions.
Worn frictional padding of the
Replace clutches.
clutch
Incorrectly installed clutch.
Install according to technical
documentation.
Insufficient brake
Improper setting.
Setting according to
force.
instructions for use.
Grease on the padding of the
Replace the brake belt.
brake belt.
Damaged brake belt.
Replace the brake belt.
Damaged brake mechanism.
Replace damaged parts.
Other.
Contact service company.
Wire rope cannot
Improper setting of pre-brake.
Setting according to
be pulled out
instructions.
or the pulling is
difficult.
Improper setting of brake
Setting according to
instructions.
Damaged or stuck wire rope
Pull out the rope with a
tractor and, if required, install
a new wire rope.
Damaged brake belt.
Replace the brake belt.
Brake handle is not in correct
Proceed according to
position.
instructions for use.
Damaged or corroded
Grease the engagement
engagement mechanism.
mechanism with WD spray
or, if required, replace the
engagement mechanism.
Other.
Contact service company.

Uniforest 35M Specifications

General

Brand	Uniforest
Model	35M
Category	Winches
Language	English