Unique Classic Plus - Page 25

1. CAUTION: Before proceeding with the conversion, shut off the gas supply to the
appliance prior to disconnecting the electrical power
2. Locate convertible regulator at the
back of the range, left side facing
back of appliance. Unscrew cap to
locate pin.
3. On the side of the pin you will see the
respective marking for LPG and NG.
4.UnscrewpinandipittotheLPGpo-
sition ( arrow facing cap indicating correct setting)
5. Replace the cap back on the regulator
Top Burner Orices
6. Remove the grates, burners and burner
caps from the range to
accesstheorices.
7. Use a 7mm wrench to remove the ori-
ces.Eachoricecanbeaccessedeas-
ily-thelargerburneroriceislocatedon
the burner wall.
8.RemoveallNGorices,placeinthebagandstoreinasafeplace.
9.TaketheLPGoricesprovidedandinstallthemasshownbelow.
See below for rating of orice for each model
20” Model
Smallest Medium Largest x 2 Oven Broil
LPG 0.57 mm 0.83 mm 0.93 mm 1.00 mm 0.62 mm
24” Model
Smallest Medium x 2 Largest Oven Broil
LPG 0.57 mm 0.93 mm 1.00 mm 1.07 mm 0.93 mm
10.Oncealltheoricesareinstalled,replaceallburnersandburnercaps,thenre
uptheburnerstochecktheminimumameheight.
GAS RANGE CONVERSION (continued)
25