Unique Classic Plus - Page 41

41
CARE AND MAINTENANCE
(continued)
Repair Parts
When repair parts are needed, contact the dealer from whom the range
was purchased. In case your range was purchased from a source other
than an appliance dealer, you may prefer to contact the manufacturer at
the address shown in this manual.
Moisture
Duringtheinitialheat-upofyourrange,theheatmixingwiththecooler
air in the oven cavity may produce fogging of the door glass or a collec-
tionofwateronthedoor.Topreventthis,opentheovendoorfortherst
few seconds of initial oven heat-up. This will allow the moist air within
the oven to escape, without the forming of visible moisture on the range.
The amount of moisture will depend upon the humidity of the air and wa-
ter content of the food being cooked. Fogging and even dripping water
will usually occur in geographic locations of high humidity.
BURNERS AND CAST-IRON GRIDS
•Thesepartscanberemovedandcleanedwithappropriateproducts.
•Aftercleaning,theburnersandtheiramedistributorsmustbewelldriedand
correctly replaced.
•Itisveryimportanttocheckthattheburneramedistributorandthecaphas
been correctly positioned - failure to do so can cause serious problems.
•Inapplianceswithelectricignitionkeeptheelectrodecleansothatthesparks
always strike.
Note: To avoid damage to the electric ignition do not use it when the
burners are not in place.