Unison Research
Unico CD
13
1. UNPACKING
Please make sure that the packaging is undamaged and the product has not
suffered from rough handling during transportation, otherwise we highly
recommend to contact your Authorised Dealer for advice before proceeding
to install the unit.
Carefully remove your CD player and all the accessories from the carton.
Note that some parts, the valves in particular, may be packed separately to
ensure safe transportation. Please refer to section 4 of this manual to insert
them properly into their sockets.
IMPORTANT! After unpacking please allow some hours before
operating the device in order to let it adapt to the room temperature.
This time is needed to prevent any possible damage due to the
condensation which can eventually form during transportation. Please
note, that condensation can form every time the CD player is moved
from a cold to a warm place.
Keep all packing materials: every time you will need to transport the Unico
CD player, its original purpose-designed carton will provide the safest
packing.
2. INSTALLATION
The CD player should be positioned in a safe place on a plane surface.
Adequate clearance must be left above and around the CD player to
guarantee a correct ventilation.
We also suggest to leave enough free space behind your Unico CD to allow
the connecting cables sufficient room to bend without crimping or strain,
and we strongly recommend not to place the CD player directly on a power
amplifier top surface or, in general, close to a heat source.
3. CONNECTION TO THE MAINS
The Unico CD is set at the factory to the appropriate mains voltage of the
country it will be shipped to.
IMPORTANT! The voltage setting may not be changed by the user.
Never connect the CD player to AC mains if the local voltage doesn’t
match the value indicated on the rear panel!
To Next Page
Loading...
Need help?
General
