Unitech MS837 - Quick Start Guide Manual

Connecting and disconnecting the interface cable
An audible “click” sound indicates the interface cable has been plugged in correctly and the connector lock is engaged. To unplug the interface cable,
release the connector lock by inserting one end of a paperclip into the handle.
SETUP AND INSTALLATION
The following steps will walk you through the installation process.
SETTINGS AND CONFIGURATION
The following section covers the most common conguration
settings for your MS837 scanner.
For additional conguration options please visit
unitechscanners.com/MS837 and select the “Download” tab.
You will nd the User’s Manual and a variety of other resources.
Open a word processing program such as Microsoft Word or Notepad
on your host. Now scan the following barcode:
Test & Finish
If the word “Unitech” appears on the screen you have succesfully
installed your scanner. Congratulations!
MS837 Quick Start Guide
The Unitech MS837 Laser Scanner
Installation Instructions and Popular Conguration Settings
Plug the interface cable into a free USB port of a host computer. The
MS837 is now ready to use.
Connecting USB cable to a host
Scan this set of barcodes to switch to Flash Mode from the default
Trigger Mode. In Flash mode, the MS837 will function automatically. It
will scan at a set interval.
Flash Mode
Continuous Automatic
Scanning
1
2
Scan here to switch back to Trigger Mode. In Trigger Mode, the MS837
will scan only when the scanner button is pressed.
Trigger Mode
*
(Default scanning mode)
Trigger Mode
Default Settings
This barcode will return your scanner to its original factory
settings, a useful feature for troubleshooting purposes.
Enter Mode
Scan here to return to Enter Mode.
Tab Mode
You may wish to set your scanner to “Tab Mode.” In this mode, data will
tab over to the next column as you scan instead of jumping to the next
line. Scan the top barcode and then the bottom barcode to switch to
Tab Mode from the default Enter Mode.
1
2