Copyright 2010 Unitech Electronics Co., Ltd.
All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
English Deutsch Español Français
中文(简体)
中文(繁體)
日本語 영어
3. Position the battery pack, making sure the battery contacts are aligned
with the contacts in the compartment.
4. Align each tenon on the battery cover with each mortise on the bottom
case and wedge them into each other, as shown below.
5. Hold a portion where the tenons
are located with one hand, while
press a portion where a yellow
arrow points with the other hand.
To Next Page
Loading...
