Unitech PA600 - Page 3

- 3
2.24. Only send single command decoding chip...................................................................................................... 16
2.25. Send command to decoding chip ....................................................................................................................... 16
2.26. Send scanner command set to decoding chip................................................................................................ 17
2.27. Get scanner command set from decoding chip.............................................................................................. 17
2.28. Send scanner command set string to decoding chip.................................................................................... 17
2.29. Get scanner command set string from decoding chip.................................................................................. 18
2.30. Get scanner related version information........................................................................................................... 18
2.31. Enable prompt warming message from USI..................................................................................................... 18
2.32. Scanner working mode (available for 2D model)............................................................................................ 18
2.33. Get image (available for 2D model)..................................................................................................................... 19
2.34. Resize image (available for 2D model)............................................................................................................... 19
2.35. Save image to file (available for 2D model) ...................................................................................................... 19
2.36. Get terminator .......................................................................................................................................................... 19
2.37. Set terminator........................................................................................................................................................... 20
2.38. Get good read sound mode and sound name ................................................................................................. 20
2.39. Set good read sound mode and sound name.................................................................................................. 20
2.40. Set previewsize (only for 2D engine)..................................................................................................................20
2.41. Set previewsize time-out (only for 2D engine)................................................................................................. 20
2.42. Set good read sound mode and sound name.................................................................................................. 21
3. CONTROL COMMAND FOR DECODER CHIP................................................................ 22
4. SCANNER3.DLL – BACKWARD COMPATIBLE API FOR PT930/PT930S’S
SCANNER3.DLL........................................................................................................................27
4.1. Enable Decoder............................................................................................................................................................ 27
4.2. Disable Decoder........................................................................................................................................................... 27
4.3. Check barcode input .................................................................................................................................................. 27
4.4. Read barcode data...................................................................................................................................................... 28
4.5. Get DLL version no..................................................................................................................................................... 28
4.6. Reset all symbologies to default............................................................................................................................. 28