28
3-10 DPM,
Multiple
symbols, Structured append, etc. read setting
2D symbols read: A global setting of 2D symbols readability.
DPM format read: By setting Enable, the imager can read 2D symbols in DPM (Direct Park Marking)
format. Some barcodes in DPM format are shown below.
Multiple symbols & structured append symbols read:
1) By setting Enable, the imager allows to read multiple symbols with a single pull of the imager's
trigger. If the user pulls and holds the trigger, aiming the imager at a series of symbols, it reads
unique symbols once, beeping for each success read. The imager attempts to find and decode
new symbols as long as the trigger is pulled.
2) By setting Enable, the imager will output data only when all Structured Append symbols have
been decoded. The lower part of below figure shows an example of four Structured Append
symbols, with the same data as that in the upper symbol.
3) By setting Disable, the imager will only read the symbol closest to the aiming beam.
Single symbol (above) and Structured Append series of symbols (below) encoding
“ABCDEFGHIJKMNOPQRSTUVWXYZ0123456789ABCDEFGHIJKLMNOPQRSTUVWXYZ”
To Next Page
Loading...