SECTION C, PAGE 9
C5.1 KEYPAD & INITIATE: If you push every time one of the
three faults is detected, the electrodes will stay closed.
To release and reset the fault do one of the following even if the KEYPAD is
CLOSED:
1. Release and then close the FOOT SWITCH or HAND SWITCHES.
2. Push any button on the keypad.
C5.2 KEYPAD & KEYLOCK: This mode is useful for critical parts welding
when you want to require a supervisor to reset a fault.
If you push every time one of the three faults is detected, the
electrodes will stay closed.
To release and reset the fault do one of the following:
1. If the KEYLOCK is in the OPEN position, press
2. If the KEYLOCK is in the LOCK position, turn the KEYLOCK to OPEN and
then press
C6 FAULT RELAY MODE: The FAULT RELAY can be used in two
modes:
1. CLOSE FOR REJECTED WELD. In this mode, the relay will close after a
weld with any of the faults in C4.
2. CLOSE FOR ACCEPTED WELD. In this mode, the relay will close after a
weld has been completed with NONE of the faults in C4.
To select the desired mode, push:
To Next Page
Loading...