SECTION C, PAGE 14
To select FORGE DELAY, press . The display will show:
and then exit out.
If you have selected FORGE DELAY, a new line will appear in all welding programs:
In this mode, the SV0 output turns ON at a timing that starts at the beginning
of WELD TIME. If there are using PULSATION in the welding program, the
timing starts at the start of the last IMPULSE.
and exit out.
If you are in this mode, a new line will appear in all welding programs:
FORGE DELAY time starts at the beginning of the WELD TIME. If your welding program uses
PULSATION, this FORGE DELAY TIME starts at the beginning of the last WELD IMPULSE.
C10.2 INTENSIFIER DELAY: This function is used for welders that have
intensifier cylinders. The most common brand of these is OHMA.
If you push the display will show:
and exit out.
SVO FUNCTION IS:
FORGE DELAY
SVO FUNCTION IS:
FORGE DELAY =2
SVO FUNCTION IS:
INTENSIF. DELAY =3
If your welder has the SOFT TOUCH option installed, this function will be
handled by SOFT TOUCH. This mode should be left in SOFT TOUCH = 6
mode.
To Next Page
Loading...