Unitronics V200-18-E1B - Transistor and Analog Input Specifications; Transistor Outputs Specifications; Analog Inputs Specifications; Environmental Specifications

Snap-in I/O Modules
Unitronics
7
Transistor Outputs
Number of outputs
4. Each can be individually wired as pnp (source) or npn (sink).
Output type
pnp: P-MOSFET (open drain)
npn: open collector
Galvanic isolation
Yes
Output current
pnp: 0.5A maximum (per output)
Total current: 2A maximum (per group)
npn: 50mA maximum (per output)
Total current: 150mA maximum (per group)
Maximum frequency
20Hz (resistive load)
0.5Hz (inductive load)
High speed output maximum
frequency (resistive load)
pnp: 2kHz
npn: 50kHz
See Note 4
ON voltage drop
pnp: 0.5VDC maximum
npn: 0.85VDC maximum
Short circuit protection
Yes (pnp only)
Power supply
operating voltage
nominal operating voltage
20.4 to 28.8VDC
24VDC
npn (sink) power supply
operating voltage
3.5V to 28.8VDC, unrelated to voltage of either the I/O module or the
controller
Notes:
4. Outputs #12 and Output #13 may be used as high-speed outputs
Analog Inputs
Number of inputs
3 (single-ended)
Input range
0-10V, 0-20mA , 4-20mA. See Note 5.
Conversion method
Successive approximation
Resolution (except at 4-20mA)
10-bit (1024 units)
Resolution at 4-20mA
204 to 1023 (820 units)
Conversion time
Synchronized to scan time
Input impedance
>100KΩ—voltage
500Ω—current
Galvanic isolation
None
Absolute maximum rating
±15V—voltage
±30mA—current
Full-scale error
±2 LSB (0.2%)
Linearity error
±2 LSB (0.2%)
Notes:
5. Note that the range of each I/O is defined both by wiring and within the controller’s software.
Environmental
IP20 / NEMA1
Operating temperature
0 to 50C (32 to 122F)
Storage temperature
-20 to 60 C (-4 to 140F)
Relative Humidity (RH)
5% to 95% (non-condensing)
Dimensions
Size (WxHxD)
138x23x123mm (5.43x0.9x4.84”)
Weight
222g (7.8 oz)
The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its sole discretion, and without notice, to discontinue or
change the features, designs, materials and other specifications of its products, and to either permanently or temporarily withdraw any of the forgoing from the market.
All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied warranties of merchantability, fitness for a particular
purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the information presented in this document. In no event shall Unitronics be liable for any special, incidental,
indirect or consequential damages of any kind, or any damages whatsoever arising out of or in connection with the use or performance of this information.
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G) Ltd. or other third parties and you are not permitted to
use them without the prior written consent of Unitronics or such third party as may own them
UG_V200-18-E1B.pdf 09/22