Universal Audio Enigmatic - Page 2

Power Supply Isolated 9VDC, center-negative, 400 mA
minimum, 2.1x5.5 mm barrel connector
(sold separately)
Find complete documentation at
uaudio.com/uafx/start
VOLUME
Adjusts amp gain
{ ROOM }
Adds studio ambience and air
BASS
Adjusts low end amount
{ DEEP/MID }
Switches Deep/Mid off below noon,
on above noon
MIDDLE
Adjusts midrange amount
{ PRESENCE }
Adjusts high end sparkle
TREBLE
Adjusts high end amount
{ BRIGHT }
Switches between no bright cap (counter-clockwise)
and three bright cap values from classic amps
OVERDRIVE
Adjusts amount of overdrive
OD channel off when fully counter-clockwise
{ RATIO }
Adjusts OD channel output level
OUTPUT
Overall pedal volume control
MONO IN
Connect TS cable from guitar or other gear
for mono operation
STEREO IN
Connect TS cable for stereo only
(in addition to MONO IN)
STEREO OUT
Connect TS cable for stereo only
(in addition to MONO OUT)
POWER IN
Connect 400 mA isolated power supply
(sold separately)
USB TYPE-C
Connect to computer for firmware updates
with the UA Connect desktop app
PAIR
Activate Bluetooth discovery for
UAFX Control mobile app
MONO OUT
Connect TS cable to amp or other gear
for mono operation
ON
Toggles amp on/off*
LED lit when knob settings are active
PRESET
Toggles preset on/off*
LED lit when stored settings are active
*Customize your amp tones and footswitch
modes with the UAFX Control app
SWITCH
{ ALT }: Activates Room, Ratio, Deep/Mid,
Presence, and Bright controls
AMP: Standard knob controls
STORE: Hold down to save sound as preset
CAB
Cycles through available speakers
When LED is off, amp remains active
but cab and room are disabled
TONE*
ROCK: Extra preamp gain and aggressive
mids for overdriven tones
JAZZ: Clean and high headroom, with
scooped mids for a tighter feel
CUSTOM: FET preamp circuit and amp mods
for big, crystalline tones