Saving a Rig with the footswitches
You can edit a Rig with the knobs and switches, and save it temporarily by pressing and holding
the active footswitch (or the left footswitch in Delay | Reverb footswitch mode) until the LED
flashes. This saves the Rig's state. You can then switch to other Rigs or power off the pedal, and
the changes will remain. You can later save the Rig permanently in the UAFX Control app.
For related details, go here.
Left Footswitch LED
The left footswitch LED is lit red when Rig A is active.
Left Footswitch
Press to toggle Rig A on/off.
Right Footswitch LED
The right footswitch LED is lit green when Rig B is active.
Right Footswitch
Press to toggle Rig B on/off.
Using OX Stomp with UAFX Control
This section describes how to operate the UAFX Control app functions that are unique to OX
Stomp. To learn more about how to connect and operate UAFX Control, see the UAFX Control
Manual.
To Next Page
Loading...
