Universal Electronics DVR M1055F - To De-Activate Channel Control Lock; To Activate Channel Control Lock; Programming Channel Control Lock

15
PROGRAMMING CHANNEL CONTROL LOCK
By default,the Cogeco Atlas DVR 5-Device Universal
Remote Control’s channel-control capabilities are unlocked.
NOTE: This feature does not affect the AUD mode.
To Activate Channel Control Lock:
1. On the remote control, press CBL once; it will
blink once.Then press and hold SETUP until
the CBL key blinks twice,then release SETUP.
2. Enter 9 -7- 3.The CBL key will blink twice.
3. Press CH+ once. The CBL key will blink twice.
4. Now, regardless of what mode you select
(except AUD),only the channel control
capability of your cable converter will be
accessible.
To De-Activate Channel Control Lock:
1. On the remote control, press CBL once; it will
blink once.Then press and hold SETUP until
the CBL key blinks twice,then release SETUP.
2. Enter 9 -7- 3.The CBL key will blink twice.
3. Press CH- once. The CBL key will blink
four times.
4. Now, the remote control will provide TV and
VCR channel-control capabilities while in the
TV or VCR mode.
Atlas DVR M1055F1 9/3/04 7:30AM Page 15