Universal Electronics URC2068BC2 User Manual

URC2068BC2
REMOTE CONTROL USER’S GUIDE
Guía del usuario
www.urcsupport.com
Remove battery cover.
Retire la tapa del compartimiento de pilas.
Insert 2 AA batteries. Match the + and – marks.
Coloque 2 pilas AA. Haga coincidir las marcas "+" y "-".
Replace battery cover.
Vuelva a colocar la tapa del compartimiento de pilas.
Getting Started
Primeros pasos
Tip/
Consejo:
1
2
3
The LED will blink 5 times with
each key-press when batteries
need replacement.
El LED parpadeará 5 veces con
cada presión de tecla cuando
sea necesario reemplazar las
pilas.
Make sure TV is ON before
starting remote control
setup.
Asegúrese de que la TV
esté prendida antes de
comenzar la conguración
del control remoto.
Note/Nota:
1 2
3
4
5
6
7
8
9
0
GUIDE
INFO
MENU
EXIT
PAG E
MUTE
TV CABLE
POWER
LAST
L
A
N
G

Universal Electronics URC2068BC2 Specifications

General

Type	Universal Remote Control
Brand	Universal Electronics
Model	URC2068BC2
Category	Remote Control
Number of Devices Controlled	8
Power Source	Battery
Compatibility	TV, DVD, Cable, Satellite, Audio, VCR

Summary

Getting Started with Your Remote

Remove Battery Cover

Instructions for removing the remote control's battery compartment cover.

Insert Batteries

Guidance on inserting two AA batteries, matching positive and negative marks.

Replace Battery Cover

Setup Method A: Popular Brands

Activate TV Power

Press the TV POWER key; the LED should remain ON.

Select TV Brand Code

Press and hold the digit key corresponding to your TV brand.

Confirm Setup Completion

Release the key when the TV turns off; setup is complete.

Functional Key Chart

TV Power Control

Volume and Mute Control

Enter SETUP Mode

Troubleshooting Common Issues

LED Not Blinking When Key Pressed

TV Unresponsive to POWER/VOLUME

No TV Codes Working

Setup Method B: Code Search

Start Code Search

Press and hold down the OK/SELECT key.

Confirm Code Search

Release the OK/SELECT key when the TV turns off.

Setup Method C: Direct Code Entry

Initiate Setup Mode

Press and hold SETUP until the LED blinks twice.

Enter TV Brand Code

Enter the first TV code for your brand from the list.

Test TV Control

Press TV POWER to test; setup is complete if TV turns off.

Repeat if Unsuccessful