RNDC Checklist
02-08-2016
RNDC Laser Operations Checklist
Daily Operation
1) System Set-Up
a) Setup of the VLS3.50 machine
i) Set up the Laser System on the Table.
(1) Be sure table is strong enough to hold the system and the table legs are locked.
(2) Obtain the assistance of another person. One person should grasp the front of the
laser system and the other person should grasp the back of the laser system. Place
it on top of the table.
ii) Setup Guide Sheet tells you how to assemble the cables.
(1) Note: DO Not Power on the laser system at this time.
iii) 6‟ USB cable max length. Have computer near machine.
iv) Install the provided 9-volt Thermal Sensor battery into the back of the VLS laser
system. (Initial Set-Up Only)
v) Your computer must have CorelDraw software installed and correctly configured.
b) Filtration Cart – refer to Users Guide for details.
i) Connect the short exhaust hose and secure it with the provided hose clamps.
ii) Make sure the computer is powered on and Windows is operating.
iii) Plug in a power cord to the laser‟s power inlet, then attach a USB cable from your
computer to the laser‟s USB port.
iv) Plug in a power cord to the BOFA Filter
v) Secure the Serial cable using the retainer clips.
vi) Make sure filters and covers are installed correctly.
vii) Turn on the filter.
c) USB Devices
i) Do not connect any USB devices (mouse, thumb drive, MP3 player, etc.) while
the laser system is running. Doing so will cause the job to stop and be lost.
2) Power up
a) Once the system is plugged in and connected to the filter cart and computer, turn the
system on. This can be done by pushing the Power button on the control panel of the
system or by clicking on the power button on the Universal Control Panel (UCP) on the
computer.
b) The system will automatically home in the XY axis.
c) Re-home the Z-Axis at the beginning of every day with the Home Z button on the
Viewer screen.
d) Power on Bofa filter unit.
To Next Page
Need help?
General
