Need help?Do you have a question about the Universal Laser Systems VLS3.75 and is the answer not in the manual?
General| Laser Type | CO2 |
|---|---|
| Resolution | 1000 DPI |
| Engraving Area | 24 x 12 inches (610 x 305 mm) |
| Cutting Area | 24 x 12 inches (610 x 305 mm) |
| Software | Universal Control Panel (UCP) |
| Power Requirements | 50/60 Hz |
| Laser Power | 30W, 40W, 50W, 60W, 75W options |
| Maximum Part Size | 24 x 12 inches (610 x 305 mm) |
Defines intended use and general safety precautions for operating the laser system.
Details safety procedures specific to the CO2 laser, including beam hazards.
Explains warning labels on the system and their importance for user safety.
Guidelines for selecting an appropriate environment and power source for system installation.
Instructions for installing an adequate exhaust system to manage fumes and debris.
Steps for installing the UCP software and configuring computer settings for the laser system.
Procedures for assembling the laser system and connecting hardware components.
Steps to ensure the laser system is level for optimal performance and alignment.
Completing the final electrical and USB connections for system operation.
Procedure to verify and adjust the laser beam alignment for accurate processing.
Introduces ULS laser system operation and the printer driver interface.
Explains the beginner-friendly materials database for setting laser job parameters.
Details advanced manual controls for configuring laser job settings.
Guides users through operating the UCP, including viewer and system controls.
Configuration options in the System tab and troubleshooting via the Diagnostics tab.
Instructions for loading material and initiating the laser processing job.
Methods for accurately focusing the laser beam on the material surface.
Guidelines for using third-party software and configuring the printer driver.
Details on installing and using gas assist for optics protection and process improvement.
Information on the optional compressed air source for gas assist.
How to install and use the cutting table to improve cut quality and reduce damage.
Information on High Power Density Focusing Optics and available lens kits.
Connecting and configuring the automation interface for external control.
Instructions for installing, calibrating, and using the rotary fixture for cylindrical objects.
Using the pin table to prevent scorch marks and improve material processing.
Software accessory for importing PDF and DXF files directly into the UCP.
Procedures for cleaning the laser system's interior, motion components, and enclosure.
Guidelines for inspecting and cleaning mirrors, focus lens, and beam window.
Instructions for cleaning the exhaust plenum and cooling fan filters.
Information on periodic adjustments, lubrication, and a recommended maintenance schedule.
To Next Page
