74
Maintenance
The particle filter should be inspected every 8 to 16 hours of use. Clean out the filter as necessary. The filter
can be inspected by unscrewing the lower bell-shaped portion of the filter housing (1/8 turn) and removing
the red foam filter found inside. If it needs cleaning, wash it in water, dry it thoroughly and reassemble.
Flow-Through Cutting Table
The Flow-Through Cutting Table is used to support material when cutting so that exhaust flow is redirected both
above and below the material for clean cuts. Without it, smoke and debris can build up underneath the material
causing the surface of the material to be damaged. The Flow-Through Cutting Table also helps to reduce damage
to the surface of the material from laser back reflection which can occur when the laser reflects off of the table
supporting the material if you attempt to cut without the cutting table. The cutting table is installed directly on
top of the engraving table.
Installation
1. Turn on your laser system.
2. Lower the table to the bottom of its travel.
To Next Page
Loading...
