Universal Laser Systems VLS3.75 - Pin Table; Custom (Cutting Table); Material Editor (Only available for customer materials - New or Cloned); Material Editing Window

40
Pin Table
If you have purchased this accessory, read how to install and operate this fixture in the Accessories
section of the User Guide.
Custom (Cutting Table)
This setting is used to set the height offset from the engraving table of any fixtures such as the cutting
table or any custom fixtures you might use to support the material to be processed. This value is used
along with the material thickness to move the Z axis to the proper focus height when using the auto Z
mode.
Material Editor (Only available for customer materials - New or Cloned)
This section of the driver allows you to edit new or cloned custom materials you have added to the materials
database. Please note that you cannot edit any of the standard materials that come with the printer driver.
They are read-only. You can create new materials in one of two ways. Right-clicking on a category and
selecting New Material creates a blank material record that you can fill in. Right-clicking on an existing
material and selecting clone allows you to make a copy of an existing material and then edit it. Creating or
editing materials records requires knowledge of the Manual Control features. Learn more about the Manual
Control Tab in the Manual Control section of the User Guide.
Material Editing Window
When you clone or create a new material the material editing windows appears with the following
controls:
Material Name
Enter a name for your new material here.
Category
Select the category you want your new material to appear under from this pulldown menu.
Options
Material Enabled
This switch controls whether the material is visible or not in the materials tree. If you hide a
material this switch is set. To restore materials that are disabled (hidden) Press CRTL F2.
Fiber/CO
2
Laser Support
Select one or more of the lasers offered by ULS (the laser must be compatible with your
particular laser system) either Fiber (1.06 micron), CO
2
(10.6 micron) or CO
2
(9.3 micron) to
make the material record available when that particular type of laser is installed in your laser
system.
3D Support
Select this switch if the material supports 3D mode and adjust default 3D power levels for this
material using the 3D Power button. For more information about 3D mode see the manual
driver section.
Can be Vector Cut
Select this switch if the material can be cut and enter information in the vector cut section.