Page 32
Erasing MacroPower & Other
Macro Commands
STEP 1: To erase MacroPower commands
on the POWER [ON] or [SYSTEM OFF] but-
ton, press and hold either the POWER [ON]
or [SYSTEM OFF] button and the [MUTE]
button simultaneously for two seconds until
the current status component LED turns on.
IMPORTANT: If you don’t proceed to the
next step within 30 seconds, the LED will
turn off and exit set-up mode and you will
need to start over.
STEP 2: Press the CHANNEL UP [CH
]
button to erase and exit Erase mode. The
component LED light will blink three times to
confirm the erasure.
NOTE: To erase other Macros, simply press
the appropriate button in Step 1 in combina-
tion with the [MUTE] button.
POWER
ON
SYSTEM
OFF
CHANNEL
UP
MUTE
To Next Page
Loading...
