Universal Remote Control omega MX-650 - Recalling Pre-Programmed Settings

27
Universal Remote Control, Inc.
Recalling Pre-Programmed Settings
If you didn’t write down the code numbers you setup your Omega with,
you can recall them via this simple process:
Enter SETUP mode by pressing and holding both MAIN and ENT
for three seconds.
Note: You have 30 seconds for each step, otherwise the Omega will time
out automatically.
Press the RECAL button. The display changes to the first page of the
four recall screens. Press the PAGE button to see the other pages.
Write down the code numbers as they appear.
Return to normal operation by pressing the MAIN button twice.
1
2
3
4
PAGE
Button