Universal Remote Control omega MX-650 User Manual

5
Universal Remote Control, Inc.
Basic Setup
You can start setting up your Omega using either the Pre-Programmed
Method or the Learning Method. However, all the buttons of the Omega
are setup at once with the Pre-Programmed Method, so it is usually faster
than the one-button-at-a-time Learning Method.
Pre-Programmed Method
Power on the A/V component you wish to setup, so that you can test
codes by sending power off commands.
Refer to the pre-programmed code tables on pages 37 - 52 and
write down the code numbers listed for your A/V component. The
code numbers are listed by categories of devices, then by brand.
See page 37 for a category list. Code tables with model numbers
are available at www
.universalremote.com in the MX-650 area.
Press and hold both the MAIN and ENT (Enter) buttons for approxi-
mately three seconds. The top of the display will show “SETUP”.
You are in SETUP mode now.
Note: You have 30 seconds to perform a step while you are in SETUP mode. If
you don’t press a button within that time, the Omega will time out and return to
normal operation.
MAIN
Button
ENT
Button
1
2
3

Universal Remote Control omega MX-650 Specifications

General

Brand	Universal Remote Control
Model	omega MX-650
Category	Universal Remote
Language	English