Repeat steps one through nine for each of your devices. If you are
missing any commands, use the learning method, described next
10
9
MX-350
Learning Method
The Osiris can learn commands from your old remote controls one-but-
ton-at-a-time by following these simple steps:
Line-up the Osiris with your old remote control, head-to-head,
one or two inches apart.
Press and hold the MAIN and ENT (Enter) buttons at the same time
for approximately three seconds. The top of the display will show
“SETUP”. You are in SETUP mode now.
Note: You have 30 seconds to perform a step while you are in SETUP mode. If
you don’t press a button within that time, the Osiris will time out and return to
normal operation.
Press the LEARN button.
The top of the screen will change to “LEARN”.
LEARN
Button
1
2
3
SETUP
P-PRO
LEARN
EDIT
MACRO
FAV
1 0F 2
LEARN
To Next Page
Loading...
Need help?
General
