In this step you verify the type of component you plan to operate
with this device button. If the flashing name is correct, press
SELECT.
If the name flashing in the display is incorrect (for example, you are setting up
AUX to operate a Laser Disc Player), use the UP and DOWN buttons to
change the flashing name to the correct type of component.
Note: Each name that appears in the display may include several types of
components. For example, the DVD category includes DVD players and
Laser Disc Players. See page 33 for a list of component types each Code
Table contains.
Point the Osiris at the component, then enter the first three digit
code number from your notes using the numbered buttons. After
you enter each three digit number, look at the component to see if
it turned off.
Continue to enter code numbers until the
component powers off.
For Example: I have a Sony TV. I found the code
numbers 070, 139,147, 126, 185, 194 and 085 under Sony in the TV
TABLE. Using the numbered buttons on the Osiris, I entered 070 and
looked at the TV. It
didn’t turn off, so I entered 139, then 147 and so on, until I found the code
that powered off the TV.
6
7
SELECT
Use the
number
buttons to
enter the
code
number.
7
MX-350
To Next Page
Loading...
Need help?
General
