If the Learning Method does not work, here are
a few suggestions:
• If you have a Plasma TV, move to another room
• Avoid programming under fluorescent light or direct sunlight
• Put new batteries in your old remote
• Gradually vary the distance between the two remote controls.
• Tap the button on your old remote instead of pressing and holding
it during the learning process.
See the following notes regarding the
Learning process:
• Learned functions override any existing pre-programmed
functions on the remote control.
• All buttons for the seven component modes can be learned
except for the LIGHT button.
• Learned functions are automatically erased when a new
function is learned on the same button.
• Learned functions are retained even after a different Set-up
Code number is programmed into the remote control.
• To return to an original pre-programmed function, a learned
function must be erased.
17
To Next Page
Loading...
