Universal Remote Control Universl Remote User Manual

SECTION 2: Erasing All Learned Commands from
One Component Mode
This function allows you to erase all the learned commands from
one component. For example, if you want to erase all learned
commands on the TV component button because you bought a
new TV, the process is very simple.
STEP 1: Press and hold both the desired component button and
the ENTER (ENT) button at the same time for about 3 seconds until
the component LED light turns on.
STEP 2: Press and hold both the desired component button you
want to erase and the PAUSE button for about three seconds, until
the component LED light blinks twice to confirm the erasure.
STEP 3: To exit, press and hold both the component button and
the ENTER (ENT) button until the component LED light blinks
three times.
29
IMPORTANT: If you don’t press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and you will need
to start over.

Universal Remote Control Universl Remote Specifications

General

Brand	Universal Remote Control
Model	Universl Remote
Category	Universal Remote
Language	English