Universal Remote Control UR3-SR3 User Manual

STEP2 Press and hold the [DEVICE] key for 5
seconds until the Device LED will blink
once and stays on. Continue to hold the
[DEVICE] key and press the number key
assigned to your brand in the Quick Set-
up Code Table and release both [DEVICE]
key and the number key to save the
code. The Device LED will blink twice to
confirm that the code is stored.
STEP3 Point the remote control at the
component.
STEP4 Press the [DEVICE] button. If it turns off,
it is programmed for your component. If it
does not turn off, use the Pre-
Programmed 3-Digit code Method or
Scanning Method.
Repeat the steps above for all components (CBL,
TV, DVD).
B. Quick Set-up Code Tables
B. Quick Set-up Code Tables
3
Quick Number
Manufacturer/Brand
CBL
0 PACE DTA
1 SA/CISCO, SAMSUNG, PACE DIGITAL
2 MOTOROLA DIGITAL
3 MOTOROLA DTA
4 EVOLUTION DTA
5 CISCO IPTV
6 ADB IPTV
7 TECHNICOLOR
8 AMINO 140/540 IPTV
9 MOTOROLA IPTV

Universal Remote Control UR3-SR3 Specifications

General

Brand	Universal Remote Control
Model	UR3-SR3
Category	Remote Control
Language	English